Notes on the use of fiber optical patch cord

Aug 03, 2020

Leave a message

Do not over-bend and loop the optical fiber during use, as this will increase the attenuation of the light during transmission.
After using the fiber jumper, be sure to use a protective cover to protect the fiber connector. Dust and oil will damage the coupling of the fiber.


If the fiber connector is dirty, you can clean it with a cotton swab dipped in alcohol, otherwise it will affect the communication quality.


1. Before use, the ceramic ferrule and end face of the fiber jumper must be wiped clean with alcohol and absorbent cotton.
2. The minimum bending radius of the fiber is not less than 150mm when in use.


3. Protect the ferrule and the end face of the ferrule to prevent bumps and pollution. Wear a dust cap in time after disassembly.
4. Do not look directly at the end face of the optical fiber while transmitting the laser signal.

5. When there is damage caused by man-made or other force majeure, the damaged fiber jumper should be replaced in time.


6. If the optical fiber network or system is abnormal, you can use the troubleshooting method to test one by one. When testing or troubleshooting jumper faults, you can do a continuity test first, usually you can use a visible laser pointer to judge the entire optical fiber link. Or further use a precision optical fiber insertion loss return loss tester to test its various indicators. If the indicators are within the qualified range, the jumper indicates normal, otherwise it is unqualified.

Patch Cord

Send Inquiry